Photo of spread tube base on the concrete barrier install of the spread tube sign support system design. photos of the spread tube sign support system. 3 series of photos. A wide shot, a photo of the U shape at the back of the sign, and the spread tube base on the concrete barrier.

Spread Tube Sign Support System

Report Number(s): Test Report 0-6646-1, Test No. 466462-1

Description: There are 4 tests within this report and all the tests share the same barrier and sign panel assemblies, but each test has a different sign mounting assembly design. The concrete barrier: 32 inch height barrier assembly which consists of there TxDOT 30-ft New Jersey shape CMB barriers that were placed longitudinally next to each other. The 30-ft barriers were secured to each other via a steel grid inserted at their end openings, and the steel grid and the cavities where filled with concrete. This now 90ft NJ barrier was placed against an existing TxDOT T223 bridge rail. The Test Article Design: For test 466462-1, the sign post is a standard 2.5-inch diameter Schedule 80 post. The post is mounted inside a 6-inch long, 3-inch diameter schedule 40 pipe that is built inside a 6-inch wide × 2-inch deep × ¼-inch thick steel tubing. The post is secured to the pipe using a ½-inch diameter through bolt. The steel tubing is 48 inches long with a 45-degree taper at each end and fixed to the top of the concrete barrier using four 8-inch long, ¾-inch diameter anchor rods.

Test Level: 3

Barrier Type: Pre-cast

MASH Test Number: 3-11

Proprietary/Non-proprietary: Non-proprietary

Pass/Fail: Pass

Evaluation: Full-Scale Crash Testing

Sponsor: TxDOT & FHWA

Test Article Description

Base Type: Frangible/Yielding

Number of Legs: 1

Support Type: Standard TxDOT U-bracket

Support Size: schedule 80 post

Support Material: Steel

Sign Material: Aluminum

Sign Size: 48" x 72"

Report(s):

Test Report 0-6646-1 and Test No. 466462-1